50M Sealing Cord

 

Composition: Polyamide thread with inert proprietary paste

Appearance : White color, coated wet cord

 

50M sealing cord is a new, faster, more versatile pipe sealant which out-dates traditional tapes and hemp/pastes combinations. Impregnated with paste to give a high pressure seal to your joints. It should be wound a few times around the thread and once the joint has been closed tightly, will withstand pressures in the region of 40 bar. Use for cold and hot water applications, as well as potable water or gas. Use on copper, steal or plastic pipe systems.

 

Usage:

1. Thread must be cleaned by brush , then wind onto the thread following the direct of the thread

2. Turns: Refer to the form , if it’s used to the plastic pipe ,30% of the turns added will be recommended regardless the space of the thread Cut the string direct by the edge of the packing

3. It’s very useful when adjust loosen or tighten disassemble and wind up

 

Pipe Diameter	Number of turns ( wraps)
	Metal	Plastics
1/2〞	6 -8	12-15
3/4〞	7-9	15-25
1〞	8-12	20-30
1/2〞	10-15	25-35
2〞	15-25
2 1/2〞	20-30
3〞	25-35
3 1/2〞	30-40
4〞	35-45

 

 

 

 

FAQ:

  

Customer: Is ptfe tape really chemically resistant?

Foreverseal: Actually, ptfe tape is immune to virtually all chemicals, including patrol and most acids.

 

Customer: Do you have WRAS for the ptfe tape?

Foreverseal: Yes, we have

 

Customer: What PTFE Tape Alternatives are Available?

Foreverseal: Pipe joint compounds (also known as pipe dope or pipe glue) can be used instead of PTFE tape. However, it should be noted that these alternatives typically have higher strength than tape so are ideally suited as permanent seals rather than temporary solutions.